![]() ![]() This is the side that will attach to the Kinect sensor. Cut a 4-inch length of velcro from the 18x3/4 roll (hook and loop) and attach the loop strip centered and perpendicular to the opposite end of the wider strip you just laid down, and nearly flush to the edge of the square plate.įlip the square plate over and attach the third 4x3 velcro strip (loop) lengthwise to the edge opposite of the wide strip on the flip side. The PVC pipe will eventually attach to this side of the square plate. Affix one of the 4x3 velcro strips (loop) to the pipe lengthwise.Īttach the opposite side of a 4x3 velcro strip (it should be the complementary side of the velcro strip you attached to the pipe, which in this case is hook) to the square plate lengthwise, making sure to align the narrower end of the strip to one edge of the plate. It's your call which side to use, but be aware that you'll have to reverse my instructions to keep the ends matching.įirst, grab the PVC pipe and make sure the surface is clean. To help things along, I'm going to refer to the velcro strips sides as either hook (scratchy) or loop (fuzzy). The trickiest part about working with velcro is remembering which parts attach to other parts. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |